FYP Sem II : Week 8

Title of Activity:

Drilling and placing the components to PCB Board to solder them

Analysis:

• After the process of PCB fabrication is done, the components  are needed to be placed one by one. The correct size of component's hole is needed to be drilled according the the leg size.

 Drilling the big size of hole for PCB stand.

 Drilling the component's size of hole.

 Complete PCB drilling.

• Once the component is matched with the hole that has been drilled, prepare the soldering gun and tin.

•  Try to fit the leg size of components and soldered it properly. 

 

Trying some of the components at the PCB board to whether it fits or not.

Soldering the components leg

• To make the board look neat, the extra leg from the component is cut. 

     

• The same process is keep on continuing until the last component is being placed.

• The final PCB board is now completed and it will be looked like the pictures below:

Conclusion:
The PCB board is now ready to be tested. After all the component had done soldering, I need to make sure that all connection from PCB board especially to RFID reader, and RS232 to serial port has the correct one.